Configuring Tcp/Ip Settings - Overland Storage SnapServer Administrator's Manual

SnapServer 7.0 Administrator's Guide

Configuring TCP/IP Settings

To configure the TCP/IP settings of a specific port or bond, click the name on the primary
TCP/IP page. A secondary TCP/IP page displays the configuration options for the Ethernet
port selected.
The following table describes these TCP/IP options.
Option
Enable
Ethernet 1
TCP/IP
Addressing
10400317-001 10/2011
Setting Description
Checked By default, all Ethernet ports are enabled, whether they are
used or not.
Unchecked Ports other than the Primary Interface (by default, Ethernet 1)
can be disabled by selecting the port and unchecking the
Enable Ethernet 1 checkbox. However, a bonded Ethernet
port cannot be disabled, nor can a disabled Ethernet port be
placed in bonded mode.
NOTE: The primary Ethernet port must always be enabled.
GuardianOS will not allow you to disable it.
DHCP By default, SnapServers acquire an IP address from the DHCP
server on the network.
Static Administrators may assign a fixed IP address or other IP
settings as needed.
©2010-11 Overland Storage, Inc.
3 – Network Access
3-5