If Access Number Management for an Address Book is set to 'On', and you want
to select a destination that is stored with an access number or in a private
address book, press [Access Number] and enter the access number to specify
the address, then press [OK]. If you press [No Access Number] the destinations
that are not managed with the Access Number setting are displayed. (See
"Storing New Addresses (Store/Edit Address Book)," on p. 4-5.)
The specified mode is set.
NOTE
•
For recipient's settings, see "Specifying a Destination Using the Address Book
(Address Book)," on p. 1-37.
•
You cannot select multiple destinations.
4
Press [Done].
The display returns to the Send Basic Features screen.
5
Press
(Start).
If the original is placed on the platen glass, follow the instructions that appear on
the touch panel display. Press
is complete, press [Done].
Scanning starts.
When scanning is complete, the document is sent to the specified destination.
When the sending job is complete, a <Job Done> notification is sent to the
specified e-mail address.
(Start) once for each original. When scanning
Configuring Send Settings (Send Settings)
1
1-145