Configuring Send Settings (Send Settings); Specifying The Time To Send A Job (Delayed Send) - Canon imageRunner 2220i User Manual

Configuring Send Settings
You can enter a subject line, message body, and a reply-to address to documents
1
to be sent. You can send documents without changing any of the settings, or
configure them as needed.
When you send a document, you can also set to send it at a preset time.
NOTE
To send documents to another fax machine, it is necessary for the Super G3 Fax Board
(optional) to be installed.

Specifying the Time to Send a Job (Delayed Send)

Delayed Send enables you to store a send job in memory, and send it later at a
specified time.
NOTE
•
Delayed Send can reserve up to 120 jobs (Among these, 64 Fax jobs can be reserved.).
However depending on sending conditions, the actual number may be less than 120. The
following two conditions are typical examples:
- Sending multiple documents at the same time
- Sending large documents
•
The number of delayed send jobs could be reduced if there are other jobs without
Delayed Send settings, or depending on the specified destinations.
•
When Delayed Send is completed, the documents in memory are automatically deleted.
•
You can check the status, cancel, or change the destinations of documents for which
Delayed Send Time has been set. (See Chapter 2, "Checking Job and Device Status," in
the Reference Guide.)
1-140 Configuring Send Settings (Send Settings)
(Send Settings)