Routing Engine Module Leds In An Ex9200 Switch - Juniper EX9214 Hardware Manual

Routing Engine Module LEDs in an EX9200 Switch

Each Routing Engine module (RE module) has LEDs on the module faceplate.
describes the functions of these LEDs on the EX9200-RE and
functions of these LEDs on the EX9200-RE2.
Table 22: LEDs on the EX9200-RE Routing Engine Module
LED Label
MASTER
STORAGE
ONLINE
OK/FAIL
Table 23: LEDs on the EX9200-RE2 Routing Engine Module
LED Label
MASTER
ONLINE
Status
Blue
Unlit
Green
Green
Red
Status
Blue
Unlit
Unlit
Table 23 on page 65
State and Description
RE module is functioning as the primary.
RE module is either functioning as the backup or not
installed.
Blinking—Indicates activity on the SSD.
•
On steadily—RE module is operating normally.
•
Blinking—RE module is coming online or going offline.
RE module has failed.
State and Description
RE module is functioning as the primary.
RE module is either functioning as the backup or not
installed.
The RE is powered off
Table 22 on page 65
describes the
65