Connecting A Qfx10002 To A Management Ethernet Device; Qfx10000 - Juniper QFX10002 Hardware Manual

Connecting a QFX10002 to a Management Ethernet Device

Ensure that you have an appropriate cable available. See
Management Connections for the QFX Series" on page
You can monitor and manage the QFX10002 using a dedicated management channel. The QFX10002
has two management ports: a 10/100/1000BASE-T RJ-45 port for copper connections and a 1-Gigabit
SFP ports for fiber connections. Use the management ports to connect the QFX10002 to a network for
out-of-band management.
NOTE: You cannot use the management ports to perform the initial configuration of the
QFX10002. You must configure the management ports before you can successfully connect to
the QFX10002 using these ports. See
page 116.
To connect a QFX10002 to a network for out-of-band management (see
1. Connect one end of the cable to one of the two management ports (labeled MGMT ) on the
QFX10002.
2. Connect the other end of the cable to the management switch.
Figure 37: Connecting a QFX10002 to a Network for Out-of-Band Management
"Cable Specifications for Console and
84.
"Performing an Initial Configuration of a QFX10000 " on
Figure 37 on page 108):
108