Diagnosis By Alarm Code - Konica Minolta bizhub C200 Service Manual

Hide thumbs Also See for bizhub C200:

Table of Contents

Field Service Ver. 2.0 Dec. 2008

Troubleshooting

Diagnosis by alarm code

• This section shows diagnoses of system troubles by alarm codes and their remedies.

• The default setting for diagnostic codes is "Do not display codes." If you experience

errors frequently, setup the soft switch (MODE 020) to display diagnostic codes. Then fol-

low communication error codes tables for troubleshooting.

• Communication error codes tables shows communication error codes. Each of them is

displayed in 6 digits on reports.

Codes 00 to B4 indicate the upper 2 digits. Adding internal 4 digits to them to display 6

digits on the panel and a report.

Communication reports (TX and RX) print out diagnostic codes for up to 50 activities.

Any codes older than those activities cannot be printed.

• Before you proceed with a remedy according to the tables, make sure that the

power source cable and the connectors are connected properly.

• Setting up diagnostic code display

• See section "Soft Switch List" for setting up soft switches.

Do not display codes.

Displays codes.

8. Troubleshooting

Table of Contents