Konica Minolta bizhub C200 Service Manual page 224

Field Service Ver. 2.0 Dec. 2008
Step
Using the telephone
line modem
Setting the DIPSW for CS Remote Care
NOTE
10
• This setting is not normally necessary.
Take this step only when necessary in a
specific connecting condition.
Executing the initial transmission
1. Select [Service Mode] → [CS Remote Care],
and touch [Detail Setting].
2. Touch [initial transmission] key on the right
bottom of the screen to start initial transmis-
sion.
3. When the machine is properly connected
with the center, CS Remote Care setting
screen will be displayed.
NOTE
• The initial transmission key at the right
bottom of the screen will be displayed
11
only when the center ID, the device ID,
Telephone number of the center and the
device telephone number have been
input.
See P.191
Procedure
Using the Fax line
modem *1
Proceed to step 13.
Receiving the initial connection E-mail mes-
sage
Sending the initial connection E-mail message
from the center to the address of the copier.
NOTE
• When receiving the initial connection E-
mail message from the center while CS
Remote Care-related screen is being dis-
played, the current setting information
will be deleted, and CS Remote Care set-
ting will be displayed.
• For sending the initial connection E-mail,
see the manual for CS Remote Care cen-
ter.
• Messages can be exchanged only
between the center with initial connection
and the copier.
• The initial connection from the center will
be carried out, and the E-mail address of
the center will be stored in the copier.
• When the initial registration is complete,
the E-mail address of the center will be
displayed by selecting [Service Mode] →
[CS Remote Care] → [Detail Setting],
[Basic Setting] → [E-Mail address].
10. Service Mode
Using E-mail
183
1