Konica Minolta bizhub C200 Service Manual page 223

10. Service Mode
Step
Using the telephone
line modem
Inputting the ID Code
1. Select [Service Mode] → [CS Remote Care] → [ID Code], and touch [ID Code].
4
2. Input the seven digits ID of the service person, and touch [ID Code] again.
See P.191
Setting the date and time for CS Remote Care
1. Select [Service Mode] → [CS Remote Care], and touch [Detail Setting].
5 2. Touch [Date & Time Setting].
3. Input the date, time and the time zone using the 10-key pad, and touch [Set].
See P.191
Setting the Center ID
1. Select [Service Mode] → [CS Remote Care], and touch [Detail Setting].
6
2. Touch [Machine Setting] → [Center ID], and input the Center ID (five digits).
See P.191
Setting the telephone number of the Center
1. Select [Service Mode] → [CS Remote Care],
and touch [Detail Setting].
2. Touch [Machine Setting] → [Center Tele-
7
phone Number].
3. Input the telephone number of the center
using the 10-keys pad and [P], [T], [W], [-].
See P.191
Inputting the device telephone number
1. Select [Service Mode] → [CS Remote Care],
and touch [Detail Setting].
2. Touch [Machine Setting] → [Device Tele-
8
phone Number].
3. Input the Device telephone number using the
10-key pad and [P], [T], [W], [-].
See P.191
Inputting the AT com-
mand for initializing the
modem
1. Select [Service
Mode] → [CS
Remote Care] →
and touch [Detail
Setting].
2. Touch [AT Com-
mand].
3. Input AT Command.
9
NOTE
• Change this com-
mand only when it
is necessary.
(They do not need
to be changed in
normal condition.)
• For details on AT
command, see the
manual for the
modem.
See P.193
182
1
Procedure
Using the Fax line
modem *1
Setting the Respond Timeout
1. Select [Service Mode] → [CS Remote Care],
2. Touch [Respond Timeout] and enter the
NOTE
• Under normal conditions, there is no
See P.191
Proceed to step 11.
Proceed to step 12. Setting the E-mail address
1. Select [Service Mode] → [CS Remote Care],
2. Touch [Server for RX], and set POP3 server
See P.193
3. Press [Receive], and set the E-Mail address,
See P.193
4. Touch [Send], and set the SMTP server
See P.193
5. Touch [TX/RX Test], and press Start key to
See P.193
Field Service Ver. 2.0 Dec. 2008
Using E-mail
and touch [Detail Setting].
response timeout using the 10-key pad.
need to change the default setting.
and touch [Server Set].
address, POP3 login name, POP3 password
and POP3 port number.
Mail Check, Connection Time Out and
APOP Authentication.
address, SMTP port number, Connection
Time Out, and APOP Authentication.
carry out a transmission/reception test. If it
fails to exchange messages, see the error
message to take necessary measure, and
try again.