Konica Minolta bizhub C200 Service Manual page 191

8. Utility Mode
J. IP Relay Settings
• It is displayed only when bit 7 for the mode 381 is set to "0" by the following setting:
1
[Service Mode] → [System] → [Software Switch Setting].
(1) IP Relay Settings
Functions
• To set whether to use the IP relay function or not.
Use
Setting/ • The default setting is Yes.
Procedure
(2) IP Relay Destination Registration
Functions • Registers the address for IP relay destination.
• To enter self-domain name of the relay unit as the domain name when restricting
Use
1. Touch [Network Settings] → [IP Relay Settings] → [IP Relay Destination Registra-
Setting/
Procedure
2. Touch the number into which relay destination is to be registered.
3. Touch [IP Relay Address].
4. Enter the address for IP relay destination, and touch [OK].
5. Touch [Domain Name].
6. Enter the domain name for IP relay destination, and touch [OK].
(3) Relay Result Port
Functions
• Sets the port number for receiving communication result for IP relay.
Use
1. Touch [Network Settings] → [IP Relay Settings] → [Relay Result Port].
Setting/
Procedure 2. Enter the port number using the 10-key pad, and touch [OK].
K. RAW Port Number Settings
Functions
• Change the raw port number.
Use
1. Touch [Network Settings] → [RAW Port Number Settings].
Setting/
Procedure 2. Enter the port number using the 10-key pad, and touch [OK].
3. Touch [Default] to default the port number.
150
1
"Yes"
receiving by the domain name at the time of IP relay.
tion].
Field Service Ver. 2.0 Dec. 2008
No