One-Touch/Box Reg - Konica Minolta bizhub C200 Service Manual

8. Utility Mode
(6) Printer Adjustment
1
<Media adjustment>
Functions • Adjust the 2nd image transfer output (ATVC) on the 1st page and the 2nd page for
• This function is provided to open [Transfer Output Fine Adjustment] → [2nd Transfer
Use • To use when the transfer failure at the trailing edge occurs.
Adjustment
Specification
Adjustment To increase the ATVC value (in the direction of a foggier image):
Instructions increase the setting value in + direction.
To decrease the ATVC value (in the direction of a less foggy image):
increase the setting value in - direction.
Setting/ 1. Call the Admin. to the screen.
2. Touch these keys in this order: [Expert Adjustment] → [Printer Adjustment] → [Media
Procedure
3. Select the side of the image (Front side or Back side), on which the transfer failure at
NOTE
• Only 1st side can be selected for Envelope and Transparency.
4. Select the paper type with the transfer failure at the trailing edge.
5. Enter the new setting from the [+] / [-].
6. Touch [OK] to validate the adjustment value.
7. Check the copy image for any image problem.
F. Paper Size/Type Counter
Functions
• To register the combination of the specific paper size and the type, and set the count.
Use
Setting/ 1. Touch a key out of 1 to 10 registration keys.
Procedure 2. Touch [Change Settings].
3. Set the Paper Size/Paper Type, and touch [OK].
8.6.2

One-Touch/Box Reg.

1
• It is displayed only when bit 6 for the mode 477 is set to "1" by the following setting:
[Service Mode] → [System] → [Software Switch Setting].
A. One-Touch
See P.129
B. Index
See P.130
C. Domain Name
See P.130
D. Bulletin
See P.130
138
1
each paper type.
Adjust] of Service Mode up to administrator and the fine-adjusted value is reflected in
the Service Mode setting.
Adjustment].
the trailing edge occurs.
Also to display the count value for each combination which has been set.
Field Service Ver. 2.0 Dec. 2008
"0" (-8 to +7)