Konica Minolta bizhub C200 Service Manual page 268

Field Service Ver. 2.0 Dec. 2008
Mode
326
State
Bit
7-6 ACS parameter setting for the book scanner.
(1) Setting the software switches for ACS
• When reading the original, misjudge in ACS mode may occur due to pitch unevenness,
etc, caused by variation of reading characteristics for reading each area.
• With setting for software switch mode [312] to [336], printing area is set for each area,
and the characteristic (to judge how far it is judged as black) is changed in order to pre-
vent misjudgment.
<Definition for Area>
• With software switch mode [312] to [315], as well as [319] to [332], reading area is set.
(A) to (D) which is applied to each setting item name corresponds to the area A to D
shown below.
<Definition for ACS Parameter>
• With software switch mode [316] to [318] and [323] to [326], the reading characteristic
parameter for each reading area is set.
• (1) to (3) applied to each setting item name corresponds to the area (1) to (3) shown
below.
Default value
Bit 7654 3210
0000 0000
Setting item
Leading edge 1, Parameter (1)
Leading edge 2, Parameter (2)
Center, Parameter (1)
Posterior end 1, Parameter (2)
Posterior end 2, Parameter (3)
10. Service Mode
HEX: 00
Setting value
0 1
Parameter for center
00
(closer to the full color)
Parameter 1 closer to
01
black
Parameter 2 closer to
10
black
Parameter 3 closer to
11
black (closer to black)
A
B
C D
Description
A02FF3C528DA
227