Konica Minolta bizhub C200 Service Manual page 185

Hide thumbs Also See for bizhub C200:

Table of Contents

8. Utility Mode

(2) E-Mail Address

• To set the e-mail address to be used for this machine.

1. Touch [Network Settings] → [SMTP TX Settings] → [E-Mail Address].

2. Enter the E-mail address on the screen key board or 10-key pad, and touch [OK].

(3) SMTP Authentication User Name

• To set the user name for authentication with SMTP server.

1. Touch [Network Settings] → [SMTP TX Settings] → [SMTP Authentication User

2. Enter the user name on the screen key board or 10-key pad, and touch [OK].

(4) SMTP Authentication Password

• To set the password for authentication with SMTP server.

1. Touch [Network Settings] → [SMTP TX Settings] → [SMTP Authentication Pass-

2. Touch [New Password].

3. Enter the new password on the 10-key pad or screen keyboard, and touch [OK].

4. Touch [Confirm New Password], and enter the password again for confirmation.

E. SMTP RX Settings

(1) Self-Domain Name

• To set the domain name for this machine.

• To prevent receiving data from general public by cross checking domain names when

receiving SMTP (IP address fax/IP relay).

• IP address fax receives data only when [Self-Domain Name] on receiving side and

[Self-Domain Name] on sending side match.

• IP relay receives (relays) data only when [Self-Domain Name] on receiving (relay)

side and [Domain Name] on sending side match.

• When the receiver or the sender is not registered, it is considered to be matched.

1. Touch [Network Settings] → [SMTP RX Settings] → [Self-Domain Name].

2. Set the domain name on the 10-key pad or the screen keyboard, and touch [OK].

(2) SMTP Authentication User Name

• To set the SMTP authentication user name when using SMTP authentication func-

1. Touch [Network Settings] → [SMTP RX Settings] → [SMTP Authentication User

2. Set the user name on the 10-key pad or the screen keyboard, and touch [OK].

Field Service Ver. 2.0 Dec. 2008

Chapters

Table of Contents