Maintenance - Konica Minolta bizhub C200 Service Manual

6. Other
4. Enter the Service mode. Make individual adjustments shown in the following table in
the order listed, using the
installation and maintenance.
NOTE
• At this time, a front door must be an open state.
Order
1 Machine
2
3
4 Imaging Process
Adjustment
5
6
7 Machine
8 System
NOTE
• After replacing the service EEPROM board, be sure to make the above listed
adjustments before the first warm-up is made.
5. Turn OFF the main power switch and sub power switch.
6. Close the front door and turn ON the main power switch and sub power switch.
Check to see that warm-up and image stabilization operations are completed normally.
7. Enter the Service mode again. Make individual adjustments shown in the following
table in the order listed, using the
body installation and maintenance.
Order
1 Machine
2
3
4
5
6
7
8
9 Imaging Process
Adjustment
10
86
service call report that was
Items that require readjustment in the Service mode
Color Reg. Adjustment
Background Voltage Margin
D Max Density
Dev. Bias Choice
Exhaust Fan Stop Delay
IU Life Setting
service call report that was
Items that require readjustment in the Service mode
Manual Bypass Tray Adjustment
Printer Resist Loop
Fusing Temperature
Printer Area
Fusing Transport Speed
Printer Area
Transfer Output Fine
Adjustment
Field Service Ver. 2.0 Dec. 2008
output at the time of main body
Cyan
Magenta
Yellow
output at the time of main
Paper Feed Direction Adj.
Centering
Centering (Duplex 2nd Side)
Leading Edge Adjustment
Secondary transfer adj.
Primary transfer adj.
Ref. page
P.174
P.177
P.177
P.180
P.201
P.300
Ref. page
P.175
P.173
P.162
P.164
P.163
P.164
P.178