Clearing A Wedged Staple; In-Bin Stapler (Code J75) - Konica Minolta 1216 User Manual

Troubleshooting

Clearing a Wedged Staple

In-Bin Stapler (Code J75)

9-14 Troubleshooting
1 Holding the sorter handle, gently
slide sorter to the left, away from
the copier main body.
2 Lift handle of the stapler unit.
3 Then open the cover of the
driving portion of the stapler unit
as shown.
4 Remove wedged staple(s) from
driving portion, making sure no
used (bent) staples remain.
5 If any staples have fallen inside
driving portion cover or between
the driving portion and forming
plate, carefully remove them
using a tool with a sharp edge.
6 Check the sheet of unused
staples remaining in the stapler
and remove any bent staples
from the sheet. Then, reinsert the
unused sheet of staples into the
stapler.
7 Firmly close the driving portion
cover, until it clicks shut.
8 Holding the staple unit handle,
return it to its original position.
9 Close the sorter cover, then slide
the sorter back to its original
position.
10 Perform test stapling two or three
times using the manual staple
mode.