Show Capture Bgp-Pdu Neighbor - Dell S4810 Reference Manual

Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage At least one interface must be in Layer 3 mode for the router bgp command to
Information
be accepted. If no interfaces are enabled for Layer 3, an error message appears:
% Error: No router id
configured
BGP does not allow 23456 (AS-TRANS) as a configured AS number.
Example
Dell(conf)#router bgp 3
Dell(conf-router_bgp)#

show capture bgp-pdu neighbor

Display BGP packet capture information for an IPv4 address on the system.
S4810
Syntax
show capture bgp-pdu neighbor ipv4-address
Parameters
ipv4-address
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Version 7.5.1.0
446
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Enter the IPv4 address (in dotted decimal format) of the BGP
address to display packet information for that address.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced.
Border Gateway Protocol