Advertise Dcbx-Appln-Tlv - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

You can configure iSCSI TLVs to send either globally or on a specified interface.

The interface configuration takes priority over global configuration.

advertise dcbx-appln-tlv

On a DCBX port with a manual role, configure the application priority TLVs advertised on the interface to

advertise dcbx-appln-tlv {fcoe | iscsi}

To remove the application priority TLVs, use the no advertise dcbx-appln-

tlv {fcoe | iscsi} command.

{fcoe | iscsi}

Application priority TLVs are enabled to advertise FCoE and iSCSI.

PROTOCOL LLDP

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

To disable TLV transmission, use the no form of the command; for example, no

advertise dcbx-appln-tlv iscsi.

Introduced on the S4810.

Introduced on MXL 10/40GbE Switch IO Module.

Enter the application priority TLVs, where:

fcoe: enables the advertisement of FCoE in application

priority TLVs.

iscsi: enables the advertisement of iSCSI in application

priority TLVs.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the MXL 10/40GbE Switch IO Module.

Data Center Bridging (DCB)