Starter Inspection; On-Vehicle Inspection; Load Test - Mazda 3 Workshop Manual

Mazda 3 Workshop Manual – Engine + Wiring Diagrams + Diagnostic Trouble Codes
1 Terminal B cable
2 Terminal S connector
3 Wiring harness bracket
4 Starter

On-vehicle Inspection

1. Verify that the battery is fully charged.
2. The starter is normal if it rotates smoothly and without any noise when the engine is cranked.
• If the starter does not operate, inspect the following:
- Remove the starter, and inspect the starter unit.
- Inspect the related wiring harnesses, the ignition switch, and the transaxle range switch (ATX).
No-load test
1. Verify that the battery is fully charged.
2. Connect the starter, battery, and a tester as shown in the figure.
Downloaded from

STARTER INSPECTION

https://carmanualshub.com/ - automotive repair manuals website
B3E011918400W05