Toshiba e-STUDIO281c Service Manual page 393

(3) Remove 1 clip on the front side.
(4) Remove 2 bushings and take off the upper
transport roller.
[J] Middle transport roller
(1) Take off the ADU drive unit.
( P.17-15 "[H] ADU motor (M5) / ADU drive
unit")
(2) Remove 2 clips, 2 pulleys and 2 pins on the
front side. Then take off the timing belt.
(3) Remove 1 E-ring, 1 clip and 1 bushing on the
rear side.
(4) Take off 1 bushing on the front side. Then
take off the middle transport roller.
June 2005 © TOSHIBA TEC
Upper transport roller
Bushing
Fig.17-23
Pin
Belt
Fig.17-24
E-ring Bushing
Clip
Fig.17-25
e-STUDIO281c/351c/451c AUTOMATIC DUPLEXING UNIT (ADU)
17 - 17
Bushing
Clip
Pin
Pulley
Clip
Pulley
Clip
Middle transport roller
Bushing
17