Toshiba e-STUDIO281c Service Manual page 370

(5) Remove 2 screws and take off the thermo-
stat from the bracket.
Notes:
When installing, pay attention to the follow-
ings:
1. Make sure to fix the thermostat, and then
harness terminal in order on the bracket.
2. Make sure to keep the gap between the
fuser roller and thermostat is 0.7 mm to
2.0 mm while the fuser roller is pressed to
the pressure roller.
[J] Thermistor (THM1, 2 , 3)
(1) Take off the fuser unit
( P.16-19 "[A] Fuser unit").
(2) Remove 2 screws and take off the fuser unit
entrance guide.
e-STUDIO281c/351c/451c FUSER UNIT / PAPER EXIT SECTION
Bracket
0.7~2.0mm
Fuser unit entrance guide
16 - 30
Thermostat
Screw
Fig.16-43
Fig.16-44
Fig.16-45
June 2005 © TOSHIBA TEC