Toshiba e-STUDIO281c Service Manual page 256

Note:
Hold A, B, C and D as shown in the right-
hand figure when handling the process unit.
Note:
At the installation of the process unit, if it cannot be fully inserted, the couplings which transmit
driving force to the transfer belt may be interfering with the unit. Perform the following check, and
then install the process unit again.
1. Rotate the transfer belt drive couplings
on the rear frame of the equipment
counterclockwise by 180 degrees.
2. Push all of the 3 transfer belt drive cou-
plings on the rear frame to the inside,
and check if they have slid back to their
original position.
e-STUDIO281c/351c/451c DRUM RELATED SECTION
C
B
11 - 12
06/07
D
A
Fig.11-12
Fig.11-13
Fig.11-14
June 2005 © TOSHIBA TEC