Toshiba e-STUDIO281c Service Manual page 371

(3) Remove 1 screw of each thermistor and take
off total 3 thermistors.
Note:
When installing, be careful not to deform the
thermistor. Also, make sure that the ther-
mistor is in touch with the fuser belt.
[K] Exit sensor (S40) / Exit finger / Transport guide
(1) Take off the fuser unit
( P.16-19 "[A] Fuser unit").
(2) Open the jam access cover and transport
guide.
(3) Remove 3 screws and take off the cover (A).
(4) Remove 1 screw and bracket.
(5) Disconnect 1 connector and take off the exit
sensor.
(6) Remove 1 spring.
June 2005 © TOSHIBA TEC
Thermistor
Fig.16-46
Cover ( A )
Fig.16-47
Exit sensor
Connector
Screw
Fig.16-48
e-STUDIO281c/351c/451c FUSER UNIT / PAPER EXIT SECTION
16 - 31
Screw
Spring
Bracket
16