Toshiba e-STUDIO281c Service Manual page 235

(4) Loosen 1 setscrew and take off the drawer
feed clutch.
Note:
Attach the clutch to the shaft referring to the
figure at right.
[C] Tray drive unit
[C-1] Tray-up motor (M10)
(1) Remove the upper and lower drawers.
(2) Take off the filter bracket
( P.2-41 "[K] FIL board (FIL)").
(3) Disconnect 1 connector. Remove 4 screws
and take off the tray drive unit.
June 2005 © TOSHIBA TEC
Setscrew
Fig.10-47
0.2~0.5mm
Fig.10-48
Tray drive unit
Fig.10-49
e-STUDIO281c/351c/451c PAPER FEEDING SYSTEM
10 - 23
Drawer feed clutch
10