Note:
When installing the upper cover, make sure
the urethan seal is covered by the upper
cover.
[A-3]
Black auto-toner sensor (S13)
(1)
Discharge the developer material
(
P.12-16 "[A-2] Developer material").
(2)
Disconnect 1 connector, remove 1 screw and
take off the auto-toner sensor.
[A-4]
Doctor blade
(1)
Discharge the developer material
(
P.12-16 "[A-2] Developer material").
(2)
Remove 2 screws, release 1 hook and take
off the right cover.
June 2005 © TOSHIBA TEC
Urethan seal
Fig.12-17
Screw
Fig.12-18
Right cover
Fig.12-19
e-STUDIO281c/351c/451c DEVELOPER UNIT
12 - 17
Black auto toner sensor
12