Toshiba e-STUDIO281c Service Manual page 261

[G] Wire pad
(1) Take off the charger wire
( P.11-16 "[F] Charger wire").
Note:
When the wire pads are being installed, be
sure that pads are installed in a proper direc-
tion.
(2) Release 1 latch and take off the wire pad.
(3) Remove 1 screw and take off the pad guide.
(4) Take off the base.
Note:
When the base is being installed, be sure
that the base and the belt are engaged in the
same manner as they were before being
taken off. It is recommended to mark off the
position of each before they are taken off.
June 2005 © TOSHIBA TEC
Wire pad
Latch
Fig.11-27
Fig.11-28
Base
Fig.11-29
e-STUDIO281c/351c/451c DRUM RELATED SECTION
11 - 17
Pad guide
11