Toshiba e-STUDIO281c Service Manual page 203

[B] Developer motor (M11)
(1) Take off the developer motor drive unit
( P.9-9 "[A] Developer motor drive unit").
(2) Remove 4 screws and take off the developer
motor.
[C] Black developer lifting clutch (CLT11)
(1) Take off the developer motor (
Developer motor (M11)").
(2) Remove 5 screws and take off the bracket.
(3) Disconnect 1 connector, remove 1 bushing
and 1 gear, and then take off the black devel-
oper lifting clutch.
Note:
Place the stopper when installing the clutch.
June 2005 © TOSHIBA TEC
Developer motor
P.9-11 "[B]
Gear
Black developer lifting clutch
9 - 11
Fig.9-13
Bracket
Fig.9-14
Connector
Bushing
Fig.9-15
e-STUDIO281c/351c/451c DRIVE SYSTEM
9