(5)
Remove 1 clip, 1 collar (with bearing), 1
washer, 1 holder and 1 bushing (with bear-
ing) from the rear side of the 2nd transfer
roller.
Note:
A spring is fit in the holder. When the roller is
reassembled, make sure that the spring is
not installed incorrectly or deformed.
[J]
2nd transfer unit
(1)
Take off the right front hinge cover
(
P.2-28 "[I] Right front hinge cover").
(2)
Remove 2 screws and take off the hinge pin.
(3)
Open the 2nd transfer unit.
(4)
Disconnect 1 connector and release the har-
ness clamp.
(5)
Remove 3 screws and take off the 2nd trans-
fer gear unit.
e-STUDIO281c/351c/451c TRANSFER UNIT
2nd transfer roller
14 - 16
Clip
Washer
Holder
Bushing
Fig.14-27
Hinge pin
Fig.14-28
Gear unit
Fig.14-29
June 2005 © TOSHIBA TEC
Collar