Toshiba e-STUDIO281c Service Manual page 166

[F] Scan motor (M1)
(1) Take off the upper rear cover (
Upper rear cover").
(2) Take off the rear cover-1(
cover-1").
(3) Disconnect 1 connector.
(4) Release the harness from the harness
clamp.
(5) Remove 3 screws and take off the scan
motor with the whole bracket.
Notes:
When installing the scan motor, use the belt
tension jig (spring). The procedure is as fol-
lows.
1. Fix the screw A.
( P.6-22 "Fig.6-32 ")
2. Temporarily fix the screw B and C.
( P.6-22 "Fig.6-32 ")
3. Hook the belt tension jig to the motor
bracket and the flame.
4. The scan motor is pulled by the belt ten-
sion jig. Fix the screw B and then C at the
stopped position.
5. Remove the belt tension jig.
e-STUDIO281c/351c/451c SCANNER
P.2-32 "[T]
P.2-31 "[R] Rear
6 - 22
Fig.6-31
C
A
Fig.6-32
Belt tension jig
Fig.6-33
June 2005 © TOSHIBA TEC
Scan motor
B