Toshiba e-STUDIO281c Service Manual page 333

[M] 2nd transfer roller contact clutch (CLT15)
(1) Open the 2nd transfer unit.
(2) Disconnect 1 connector and release the har-
ness clamp.
(3) Remove 3 screws and take off the 2nd trans-
fer gear unit ( P.14-16 "[J] 2nd transfer
unit").
(4) Disconnect 1 connector. Remove 1 clip and
take off the 2nd transfer roller contact clutch.
[N] Transfer belt cleaner clutch (CLT1)
(1) Take off the inner tray (
tray").
(2) Disconnect the connector. Remove 1 clip
and slide the bushing to the rear side.
(3) Take off the transfer belt cleaner clutch.
June 2005 © TOSHIBA TEC
P.2-26 "[C] Inner
14 - 19
2nd transfer roller contact clutch
Fig.14-36
Fig.14-37
Transfer belt cleaner clutch
Fig.14-38
e-STUDIO281c/351c/451c TRANSFER UNIT
Clip
Bushing
14