Toshiba e-STUDIO281c Service Manual page 227

[A-8] Bypass pickup roller
(1) Take off the bypass upper guide (
"[A-5] Bypass upper guide").
(2) Remove the clip, pull out the shaft and take
off the bypass pickup roller.
Notes:
Make sure the following items when assem-
bling the bypass pickup roller.
1. Set the timing belt to the pulley securely.
2. Do not put the wrong position when set-
ting the timing belt.
3. Be sure to insert the clip into the groove
of shaft.
4. Check that there is no stain such as oil on
the surface of timing belt, the pulley and
the roller.
5. Install the bypass pickup roller and the
bypass feed roller in the correct direction.
[A-9] Bypass feed roller
(1) Take off the bypass upper guide (
"[A-5] Bypass upper guide").
(2) Remove the clip and take off the bypass feed
roller.
Notes:
Make sure the following items when assem-
bling the bypass feed roller.
1. Set the timing belt to the pulley securely.
2. Do not put the wrong position when set-
ting the timing belt.
3. Be sure to insert the clip into the groove
of shaft.
4. Check that there is no stain such as oil on
the surface of timing belt, the pulley and
the roller.
5. Install the bypass pickup roller and the
bypass feed roller in the correct direction.
June 2005 © TOSHIBA TEC
P.10-13
Bypass pickup roller
P.10-13
Bypass feed roller
e-STUDIO281c/351c/451c PAPER FEEDING SYSTEM
10 - 15
05/08
Clip
Shaft
Fig.10-25
Clip
Fig.10-26
10