[D] IH coil (IH-COIL)
(1)
Take off the fuser unit.
(
P.16-19 "[A] Fuser unit")
(2)
Release the harnesses from 8 harness
clamps.
(3)
Remove 1 E-ring, 1 bushing and 2 screws.
(4)
Pull out the bracket and IH coil.
(5)
Take out the IH coil from the bracket.
Notes:
1. When installing, be sure to set the har-
nesses "C" and "S" of 4 harnesses on
upper.
2. Make sure that there is not any scratch or
break on the white tube on the IH coil.
3. Make sure that there is not any peeling or
scratch on the harness tube.
e-STUDIO281c/351c/451c FUSER UNIT / PAPER EXIT SECTION
E-ring
Bracket
C
S
16 - 22
Fig.16-19
Bushing
Fig.16-20
IH coil
Fig.16-21
June 2005 © TOSHIBA TEC