Toshiba e-STUDIO281c Service Manual page 167

[G] Carriage-1
(1) Take off the original glass, upper rear cover
and front upper cover.
( P.6-17 "[A] Original glass",
P.2-32 "[T] Upper rear cover",
P.2-27 "[G] Front upper cover")
(2) Move the carriage and position the holes of
the carriage to the holes of the frame.
(3) Remove 2 screws and take off the brackets
fixing the carriage-1 to the wire.
(4) Remove the square seal fixing the lamp
cable to the base. Disconnect the connector
of the lamp cable from the SLG board.
(5) Rotate the carriage-1 in the direction shown
in the figure at right, not to touch the mirror.
Then take off the carriage-1.
Note:
When replacing the mirror-1, replace the car-
riage-1 together with mirror-1.
Mirror-1 should not be removed.
June 2005 © TOSHIBA TEC
Fig.6-34
Connector
Fig.6-35
Fig.6-36
6 - 23
Seal
e-STUDIO281c/351c/451c SCANNER
6