Toshiba e-STUDIO281c Service Manual page 375

(6) Disconnect 3 connectors, remove 2 screws
and take off the IH board case.
(7) Disconnect 4 connectors, remove 7 screws
and take off the IH board.
Notes:
1. Make sure not to connect each IH con-
nection cable to the wrong position.
2. Tighten 4 screws of the IH connection
cable completely
(tightening torque: 1.17 - 1.56 N·m).
3. Since the IH board is a highvoltage sec-
tion, make sure to disconnect the power
cable at maintenance.
[O] IH control board cooling fan (M20)
(1) Take off the IH board case
( P.16-34 "[N] IH board (IH) / IH board
case").
(2) Remove 1 screw and take off the IH control
board cooling fan cover.
June 2005 © TOSHIBA TEC
IH board case
Fig.16-58
IH board
Fig.16-59
IH control board cooling fan cover
Screw
Fig.16-60
e-STUDIO281c/351c/451c FUSER UNIT / PAPER EXIT SECTION
16 - 35
Screw
Connector
Screw
Connector
16