Toshiba e-STUDIO281c Service Manual page 294

(6) Remove the following parts installed on the
shaft of the developer sleeve in order: E-ring,
bearing, gear, bearing and oil seal.
* Procedure for replacing an oil seal:
P.12-32 "Fig.12-63 "
(7) Take off the developer sleeve.
[B-5] Mixer
(1) Discharge the developer material
( P.12-23 "[B-2] Developer material").
(2) Take off the developer sleeve
( P.12-25 "[B-4] Developer sleeve").
(3) Front side: Remove the following parts in
order: E-ring, bushing-1 and bushing-2.
* Procedure for replacing an oil seal:
P.12-32 "Fig.12-63 "
e-STUDIO281c/351c/451c DEVELOPER UNIT
Bushing-2
E-ring
12 - 26
Fig.12-43
Developer sleeve
Fig.12-44
E-ring
Bushing-1
Fig.12-45
June 2005 © TOSHIBA TEC