Toshiba e-STUDIO281c Service Manual page 369

(4) Remove each 1 ring, 1 bearing and 1 bush-
ing on both front and rear sides of the pres-
sure roller.
[I] Thermostat (THMO1)
(1) Take off the fuser unit
( P.16-19 "[A] Fuser unit").
(2) Remove 2 screws. Lift up the cleaning unit
and take it off.
Note:
When installing, fit 2 protrusions on the bot-
tom of the cleaning unit into the holes of the
frame securely.
(3) Release the harnesses from the harness
clamps.
(4) Remove 2 screws and take off the thermo-
stat unit.
Note:
Be careful not to scratch the fuser belt.
June 2005 © TOSHIBA TEC
Bushing
Bearing
Ring
Fig.16-40
Fig.16-41
Fuser belt
Thermostat unit
Fig.16-42
e-STUDIO281c/351c/451c FUSER UNIT / PAPER EXIT SECTION
16 - 29
Pressure roller
Cleaning unit
Screw
16