[G] Separation finger
(1)
Take off the fuser roller
(
P.16-23 "[E] Fuser roller / Fuser belt
guide").
(2)
Lift up the fuser belt unit and take it off.
Note:
Be careful not to scratch the fuser belt. Lay
the fuser belt on the clean place to prevent
the belt from the dust.
(3)
Confirm that the pressure releasing levers on
both sides are up. Then loosen each 1 screw
on both front and rear sides.
(4)
Remove 2 springs.
June 2005 © TOSHIBA TEC
Fuser belt unit
Fig.16-34
Pressure releasing lever
Fig.16-35
Fig.16-36
e-STUDIO281c/351c/451c FUSER UNIT / PAPER EXIT SECTION
16 - 27
Screw
Pressure releasing lever
16