Toshiba e-STUDIO281c Service Manual page 374

(3) Remove 4 screws and take off the cover.
(4) Remove 1 screw and take off the discharge
brush.
Note:
Be careful not to scratch the fuser belt.
[N] IH board (IH) / IH board case
(1) Take off the SYS board case
( P.2-35 "[D] SYS board case").
(2) Take off the flywheel
( P.9-9 "[A] Developer motor drive unit").
(3) Take off the right rear cover
( P.2-30 "[O] Right rear cover").
(4) Disconnect 2 connectors and 4 faston termi-
nal ( P.16-19 "[A] Fuser unit").
(5) Remove 3 screws and take off the IH board
cover.
e-STUDIO281c/351c/451c FUSER UNIT / PAPER EXIT SECTION
Screw
IH board cover
16 - 34
Cover
Fig.16-55
Screw
Discharge brush
Fig.16-56
Screw
Fig.16-57
June 2005 © TOSHIBA TEC