Toshiba e-STUDIO281c Service Manual page 373

(4) Remove 1 E-ring and 1 bushing from the exit
roller front side.
(5) Remove E-ring, gear unit, E-ring and bush-
ing in order from the exit roller rear side.
Then take off the exit roller.
[M] Discharge brush
(1) Take off the fuser unit
( P.16-19 "[A] Fuser unit").
(2) Remove 2 screws and take off the jam
access cover.
June 2005 © TOSHIBA TEC
Bushing
E-ring
Fig.16-52
Gear unit
E-ring
Fig.16-53
Fig.16-54
e-STUDIO281c/351c/451c FUSER UNIT / PAPER EXIT SECTION
16 - 33
E-ring
Exit roller
Bushing
Jam access cover
16