Eia Leds - Paradyne Comsphere 3920Plus Installation And Operation Manual

To change the data stream on all ports again, press the F1 key.
or
To exit this function and remain in the Control branch, press the
Top-Level menu, press the

EIA LEDs

This function allows the front panel EIA LEDs to display and change the activity of a selected
digital interface. Use the EIA LEDs function to change the port that controls the front panel LED.
Based on the modem's configuration, the following conditions exist:
To access EIA LEDs from the Control branch, make the following selections:
Press the
The port field (xxxxx) displays the currently selected interface. Valid interface selections are Port1,
Port2, Port3, Port4, and depending on the set value of the Diagnostic Connection configuration
option, CC (NMS Control Channel), or DC (Diagnostic Channel). Refer to Diag Connection
configuration option in the Misc section of Chapter 4.
Press the F1 key until the appropriate digital interface appears. Select the appropriate interface by
pressing the corresponding function key.
3920-A2-GN31-10
Select DS Port
All
F1 F2
key.
The CC or DC selection is not available if the Diagnostic Connector configuration option is
disabled. Refer to the Diag Connection configuration option in the Misc section of
Chapter 4.
The CC or DC interface is not available on the 3921Plus modem. The CC or DC activity is
monitored on the SDU in the 3000 Series carrier.
Ports 3 or 4 are not available in the DTE Bridge mode.
Ports 2, 3, and 4 are available in TDM/MSD mode.
Control:
EIA_LEDs
F1 F2
key until EIA LEDs appears. Select EIA LEDs.
EIA LEDs:xxxxx
Port1 Port2
F1 F2
April 1995
>
F3
F3
>
F3
DCP Operation
key. To exit and return to the
3-39