Paradyne Comsphere 3920Plus Installation And Operation Manual page 155

COMSPHERE 392xPlus Modems
DTE Dialer Configuration Options — Mux DISABLED
Linefeed Char: 010 ASCI
"
Nxt 010 ASCI
This configuration option only appears when DTE Dialer Type is configured for AT.
Line Feed Character. Sets the character used to perform a line feed in Command mode for responses from the modem.
The AT command is S-Register S4= n , where n is a value from 0 to 127.
Result Codes: Enable
Nxt Enable Disable EnableInOrig
This configuration option only appears when DTE Dialer Type is configured for AT.
Result Codes. Result codes are informational messages (such as Connect and Ring) sent from the modem and
displayed on the asynchronous DTE terminal. (For a list of Result Codes, refer to Table 5-1 in Chapter 5, AT Commands
and S-Registers .)
Enable – Modem sends result codes to the DTE.
Disable – Modem does not send result codes to the DTE.
Enable in Originate – For UNIX
DTE on the answer side from interpreting result codes as login attempts.
The AT command for Enable is Q0.
The AT command for Disable is Q1.
The AT command for Enable in Originate mode is Q2.
ExtendResltCode: Enable
Nxt Enable Disable Add/EC Add/V42,MNP Use_DTE_Rate
This configuration option only appears when DTE Dialer Type is configured for AT.
Extended Result Codes. Informational messages such as VF data rate and Error Control appear along with the result
codes. (For a list of Extended Result Codes, refer to Table 5-1 in Chapter 5, AT Commands and S-Registers .)
Enable – NO DIALTONE, BUSY, NO ANSWER, and CONNECT xxxx (xxxx = VF data rate) appear along with result
codes listed in Table 5-1 in Chapter 5.
Disable – Only OK, CONNECT, RING, NO CARRIER, and ERROR result codes appear.
Add/EC – Places the EC suffix after the result code text if error control is used. For example, CONNECT 9600/EC.
Add/V.42 or /MNP – Places either the /V.42 or /MNP suffix after the result code text if data compression is used. For
example, CONNECT 9600/V42b.
Use DTE Rate – Allows the DTE rate to be displayed in the Connect message instead of the line rate. This feature is
required in some modem pooling applications.
NOTE: NO DIALTONE is valid only if Dial Tone Detect configuration option is enabled. BUSY appears if Busy Detect
configuration option is enabled.
The AT command for Disable is X0.
The AT commands for Enable are X1, X2, X3, or X4.
The AT command for Add/EC is X5.
The AT command for Add/V42,MNP is X6.
The AT command for Use DTE Rate is X7.
4-42
Table 4-8
(3 of 5)
r
applications, enable result codes only on the originating modem. This prevents the
April 1995
A
3920-A2-GN31-10