Paradyne Comsphere 3920Plus Installation And Operation Manual page 54

COMSPHERE 392xPlus Modems
Type Message
Security Database Reset
Password Protect
Mode Change
Password Change
Database Change
Port 1 Rx Data Alarm
Port 2 Port 2
Tx Data Alarm
Port 3 Port 3
Port 4
DTR Alarm
CTS Alarm
RTS Alarm
DSR Alarm
LSD Alarm
Auto Stream Dis
Disabled
To exit DeviceHS and remain in the Status Branch, press the
Top-Level menu, press the
VF
VF enables you to display the condition of the leased or dial connection. VF also allows you to
clear the VF counters.
To access VF from the Status branch, make the following selection:
Select VF. The selections Display or Clear appear on the LCD's bottom line.
3-20
Table 3-6
(3 of 3)
Health and Status Messages
The security database has been reset (passwords erased).
Security password protection is enabled.
There has been a change in security mode. (Refer to Chapter 6, Dial Access
Security .)
A security password has been changed.
The security database containing passwords has been changed.
The alarming DTE port's RXD signal is in an alarm condition.
The alarming DTE port's TXD signal is in an alarm condition.
The alarming DTE port's DTR signal is in an alarm condition.
The alarming DTE port's CTS signal is in an alarm condition.
The alarming DTE port's RTS signal is in an alarm condition.
The alarming DTE port's DSR signal is in an alarm condition.
The alarming DTE port's LSD signal is in an alarm condition.
The port is disabled due to an antistreaming condition. (Refer to the Streaming
DTE message in the Major Alarm section of this table.)
The modem's alarming DTE port has been disabled.
key.
Status:
DeviceHS VF
F1 F2 F3
April 1995
Indicates
key. To exit and return to the
3920-A2-GN31-10