COMSPHERE 392xPlus Modems
Cloning DC Broadcast Remote
Before using Clone Remote in DC Broadcast configurations, make sure the tributary modem's
active poll list contains all the network management addresses for the control modems that receive
the download (refer to the Poll List Branch section in this chapter), and ensure that the control
modems are responding properly to polls (refer to the Sub-Network Health and Status branch
section in this chapter).
From the Choose DLL Type screen, press the
to transfer an exact copy of the tributary modem's firmware to the DC-connected control
modem(s) using the Active Poll list.
Proceed to the section titled Implementing a Clone Remote Operation, which follows the
descriptions of multipoint cloning operations.
Viewing DC Broadcast Clone Results
From the Choose DLL Type screen, press the
results of the last DC_Broadcast clone operation. If the message Trib List Empty appears, this
indicates that a multiple download was never initiated.
The address field (xxx) displays the network management address of one of the remote modems.
Pressing the F1 key allows you to select various remote modems to determine the download result
for those modems (Pass or Fail).
3-44
Choose DLL Type >
DC_Broadcast
F3
F1
F2
Choose DLL Type >
DC_CloneResults
F3
F1
F2
DC Clone Results
Nxt
xxx
Pass
F3
F1
F2
April 1995
key until DC_Broadcast appears. Press F1 or F2
key until DC_CloneResults appears to view the
3920-A2-GN31-10