Paradyne Comsphere 3920Plus Installation And Operation Manual page 115

COMSPHERE 392xPlus Modems
Figure 4-1 graphically displays the interaction between the edit area and configuration areas as
viewed from the perspective of the DCP.
Active (Operating)
4-2
Factory is a read-only (unchangeable) configuration area containing six sets of predefined
configuration options labeled Sync Leased, Async Leased, TMp (Trellis Multipoint),
Async Dial, Sync Dial, and UNIX Dial. If Sync Leased or Async Leased is selected, you
must choose either Answer or Originate mode. If TMp is selected, you must choose either
Control or Trib (Tributary) mode. These sets contain the most commonly used
configurations options for modems installed into these hardware environments. These
predefined configuration options are intended to give you a head start and only require a
minimum of changes to the default settings. Factory default settings are listed in
Appendix F.
CONTENTS OF Active (Saved) ARE AUTOMATICALLY COPIED
TO Active (Operating) WHEN A SAVE IS COMMANDED VIA THE
DCP, ON A RESET, OR ON POWER-UP.
Active (Saved) Customer1
Load Edit
Area From
EDIT AREA
ALLOWS YOU TO VIEW AND
EDIT CONFIGURATION OPTIONS
Save
ANY CHANGES MADE TO
To
CONFIGURATION OPTIONS
ARE SAVED TO Active (Saved),
Customer1, OR Customer2
Figure 4-1. DCP Configuration Process
April 1995
Customer2 Factory
S
Sync Leased*
(Answer/Originate)
S
Async Leased*
(Answer/Originate)
S
TMp (Control/Trib)
S
Async Dial
S
Sync Dial*
S
UNIX Dial
*Mux Enabled
3920-A2-GN31-10