Paradyne Comsphere 3920Plus Installation And Operation Manual page 53

Type Message
Status Subtree Truncate
Test Mode
Disabled
On Dial Backup
FW Downloading
Primary Line Good
Backup Line Bad
Data Blocked
On Lease Backup
PSTN Test Fail
Dial Dial Make Busy Mode Make Busy Mode
Service Line
Short Hold Time
Non-Answering
Thresh* RSL High Threshd
RSL Low Threshld
SNR Threshold
Non-linear Dist
Retrains
Signal Quality
Far Echo Threshd
Near Echo Thresh
Phase Jitter
Phase Hit Thresh
Impulses Hit
Gain Hit Threshld
Drop Outs Thresh
Frequency Offset
* Not supported in every modulation.
3920-A2-GN31-10
Table 3-6
(2 of 3)
Health and Status Messages
Downstream health and status information has been truncated because it
overflowed system limits. There is a large amount of health and status
information in the subnetwork.
The modem or an upstream device is running a disruptive test.
The modem's DTE port has been disabled.
The modem is operating in Dial Backup mode.
A firmware download is in progress.
The modem is currently operating on the 2-wire backup facility, the Lease
Lookback option is enabled, and the modem detects continuity on the primary
4-wire leased lines.
The modem is currently operating on the primary 4-wire leased facility with
2-wire leased lines selected as the backup facility, the BackupLineCheck
configuration option is enabled, and the modem detects continuity on the 2-wire
backup leased lines.
The modem's data path is blocked.
The modem is operating in 2-wire Leased Backup mode.
The modem failed either the Dial Tone Detection or the Ring Tone Detection
portion of the Call Test command.
The modem is in a Make Busy condition. The modem is in a Make Busy condition.
(Model 3921 Plus only) The modem installed in a COMSPHERE 3000 Series
Carrier has been switched to a service line.
The modem's dial hold time has been shortened.
The modem is in a non-answering mode.
The received signal level (RSL) has exceeded the upper threshold.
The RSL is less than the lower threshold.
The signal-to-noise ratio has exceeded the threshold.
The non-linear distortion exceeded the threshold.
The number of retrains exceeded the threshold.
The signal quality is less than the threshold.
The far end echo level exceeded the threshold.
The near end echo level exceeded the threshold.
The phase jitter level exceeded the threshold.
The number of phase hits has exceeded the threshold.
The number of impulse hits exceeded the threshold.
The number of gain hits exceeded the threshold.
The number of drop outs exceeded the threshold.
The frequency offset level exceeded the threshold.
April 1995
Indicates
DCP Operation
3-19