Paradyne Comsphere 3920Plus Installation And Operation Manual page 33

COMSPHERE 392xPlus Modems
If the modem is to communicate with an installed SDCP, install the modem as described above and
perform the following steps:
1. Press the
2. Press the F1 (
3. Press the
4. Press the F1 (
5. Press the
6. Once you have determined that the modem is installed properly and completed its
7. Configure the modem as described in the Selecting Factory Configuration Options section
2-10
key on the SDCP. The cursor appears in the slot selection entry.
Select
" #
) or F2 ( ) key until the carrier number you want appears on the LCD.
The carrier number selection has a range of 1 to 8 since a single SDCP can control a
configuration of up to eight carriers. (This is only possible if the SDU is installed.)
key to position the cursor on the slot selection entry.
" #
) or F2 ( ) key until the slot number you want appears on the LCD.
key to place the SDCP in direct communication with the selected
Select
modem.
The LCD displays the Top-Level menu for the selected modem. In addition, the Front
Panel LED on the modem's faceplate and the OK LED on the SDCP light.
power-up self-test, rotate the circuit pack lock until it covers the faceplate latch
(Figure 2-3) and tighten the retention screw on the circuit pack lock. This prevents the
modem from accidently being removed once it is installed in a carrier.
earlier in this chapter.
April 1995 3920-A2-GN31-10