Paradyne Comsphere 3920Plus Installation And Operation Manual page 83

If unsuccessful, the modem remains in the Download Transfer mode. The LCD's top line displays
RemClone Failed and the bottom line displays one of the following messages:
Incompat Modulat
No Response
Access Disabled
Password Invalid
No Circuit
After successful establishment of a Remote Cloning Download session, the following screens
appear.
As data banks are transferred, the local and remote LCD's bottom line displays the status of the
download process, and the number of records sent versus the total number of records for that bank.
For Single download applications, if the download is successful, the local modem displays
Remote Clone OK and the remote modem displays Frmware Upgrade. If the download took
place over the dial network, the modems disconnect when the download is complete.
If the Single download is unsuccessful, RemClone Failed appears on the LCD's top line. Attempt
another download from the local modem. If this fails, contact AT&T Paradyne's Customer
Assistance Center.
3920-A2-GN31-10
The modems are connected, but are using a modulation scheme other
than V.34 family, V.33, V.32 family, V.29, or TMp.
The remote modem is not a 3900 Series modem or the connection
between the two modems is poor.
The remote modem's Access from Remote configuration is disabled.
The local and remote modems' passwords do not match. Correct the
problem and attempt another download from the local modem. If this
fails, contact AT&T Paradyne's Customer Assistance Center.
There is no connection between the local and remote modem.
RemClone Status
Initializing
F1 F2 F3
RemClone Status
Bank1:xxxx/yyyy
F1 F2 F3
April 1995
DCP Operation
3-49