Manual Dialing When The Remote Modem Is Configured For Auto-Answer - Paradyne Comsphere 3920Plus Installation And Operation Manual

The following sections describe three uses of the Talk/Data function.

Manual Dialing When the Remote Modem is Configured for Auto-Answer

If you are originating a call using a telephone and the remote modem is configured for
Auto-Answer, perform the following procedure.
Press the
Lift the attached handset and dial the telephone number of the remote modem. When the remote
modem answers, it transmits an answer tone.
When you hear this tone, immediately select Tlk/Data and hang up the handset. This starts the
handshaking sequence between your modem and the remote modem.
If this is successful, the modems are in Data mode and OnLine appears on the LCD.
3920-A2-GN31-10
On the remote modem, the Line Current Disconnect configuration
option (refer to the Line Dialer section in Chapter 4) must be set to
Disable.
This configuration option does not appear on Models 3920-A1-401
and 3921-B1-001.
Idle:28.8
Tlk/Data
F3
F1 F2
key until Tlk/Data appears.
Idle:28.8
Tlk/Data
F1 F2 F3
Online:28.8 >
Call_Setup
F1 F2 F3
April 1995
NOTE
DCP Operation
3-73