Paradyne Comsphere 3920Plus Installation And Operation Manual page 188

COMSPHERE 392xPlus Modems
AT
Command
X n Extended Result Code, Dial Tone Detect, and Busy Tone Detect Configuration
Options.
X0
X1
X2
X3
X4
X5
X6
X7
Extended Result Code:
Enable
Disable
Add/EC
Add/V42,MNP
Use DTE Rate
Dial Tone Detect:
Enable Enable
Disable
NOTE: It may not be possible to disable Dial Tone Detect in some countries.
Busy Tone Detect:
Enable
Disable
Y n Long Space Disconnect.
Y0 Disable. Ignores long space.
Y1 Enable. Disconnects if long space is detected. Enables transmission of a
long space.
Z n Reset and Load Active.
Z0
Z1
Z2
Z3
5-8
Table 5-2
(3 of 9)
392x Plus AT Commands
Description
Extended
Result Code:
Disable
Enable
Enable
Enable
Enable
Add/EC
Add/V42.MNP
Use DTE Rate
Displays all result codes listed in Table 5-1 except for error
control suffix.
Only displays OK, CONNECT, RING, NO CARRIER,
ERROR ERROR.
Displays result codes with /EC suffix.
Displays result codes with V.42 or MNP suffix.
Displays DTE data rate instead of line rate.
Sets the modem for dial tone detect. Sets the modem for dial tone detect.
Sets the modem for blind dialing.
Modem monitors for busy tone.
Modem ignores busy tone.
Loads configuration options from Active (Saved) to Active
(Operating).
Loads configuration options from Customer 1 to Active (Operating).
Loads configuration from Customer 2 to Active (Operating).
Loads configuration options from Active (Saved) to Active
(Operating) and performs a reset.
April 1995
Dial Tone Busy Tone
Detect: Detect:
Disable Disable
Disable Disable
Enable Disable
Disable Enable
Enable Enable
Enable Enable
Enable Enable
Enable Enable
DCP LCD
Command
Sequence
Extended Result
Code:
Configure\Edit\
DTE Dialer
Dial Tone Detect:
Configure\Edit\
Line Dialer
Busy Tone
Detect:
Configure\Edit\
Line Dialer
Configure/Edit/
Line Dialer
Control\Reset
3920-A2-GN31-10