COMSPHERE 392xPlus Modems
Backup
The Status Backup function displays the configuration of the modem's current operating line
facility and the configuration and condition of the inactive line.
To access Backup from the Status branch, make the following selection:
Press the
Select Backup.
The configuration of the current operating line facility (either APL primary or backup) appears
(Refer to Table 3-7).
Press the
This screen displays the configuration and condition of the inactive line facility (either APL
primary or backup).
There are four condition codes, Good, Bad, ????, and ' ' (blank).
3-26
The modem's rear panel has two line interface jacks: LEASE and
DIAL (see Figure 2-1 in Chapter 2). The jack labeled LEASE is the
APL primary interface and accepts either 2-wire or 4-wire APL. The
jack labeled DIAL is the backup interface and accepts either 2-wire
APL (Dual Lease Line) or Dial lines.
key until Backup appears.
Status:
DTE
Backup
F3
F1
F2
Status:Backup
>
Line=Pri 4w APL
F1
F2
F3
key to display the next screen.
Status:Backup
<
Bkup:2wAPL=Good
F1
F2
F3
April 1995
NOTE
3920-A2-GN31-10