Paradyne Comsphere 3920Plus Installation And Operation Manual page 202

COMSPHERE 392xPlus Modems
S-Register
S61 CT111 Rate Control. Register determines if CT111 Rate is disabled, set for
Fallback 1 or Fallback 2.
CT111 Rate allows the DTE to control modem rate via Pin 23 of the EIA-232-D
interface. This configuration option determines the effect of the DTE Rate
Control signal. It is only valid in Async Direct mode and Synchronous mode.
For proper operation, disable the V.32bis Autorate and V.32bis Automode
configuration options.
Register has the following values:
0 = Disable
1 = Fallback
2 = Fallback 2
The factory setting is Disable.
S62 V.25bis Coding. Register identifies to the modem the type of coding used by
the DTE while in V.25bis mode.
Register has the following values:
0 = ASCII
1 = EBCDIC
The factory setting is ASCII.
S63 V.25bis Idle Character. Register identifies to the modem the type of idle fill
used by the DTE while in V.25bis mode.
Register has the following values:
0 = Mark
1 = Flag
The factory setting is Mark.
S64 V.25bis New Line Character. Register identifies to the modem the type of line
terminator used by the DTE while in V.25bis mode.
Register has the following values:
0 = Carriage Return and Line Feed
1 = Carriage Return
2 = Line Feed
The factory setting is carriage return and line feed (CR + LF).
S65 Line Current Disconnect. Register determines if the modem disconnects if an
8-millisecond or 90-millisecond interruption in loop current occurs.
Register has the following values:
0 = Enable (8msec)
1 = Enable (90msec)
2 = Disable
The factory setting is Enable (8msec).
5-22
Table 5-3
(7 of 12)
392x Plus S-Registers
Description
April 1995
DCP LCD
Command
Sequence
Configure\Edit\
DTE Interface
Configure\Edit\
DTE Dialer
Configure\Edit\
DTE Dialer
Configure\Edit\
DTE Dialer
Configure\Edit\
Line Dialer
3920-A2-GN31-10