Misc - Mux Disabled - Paradyne Comsphere 3920Plus Installation And Operation Manual

Misc — Mux Disabled
The Miscellaneous configuration options determine specifics for various functions, including
network management parameters and remote modem access.
Table 4-14 shows each Misc (Miscellaneous) configuration option as it appears on the LCD, with
the Sync Leased factory default setting (the default value if the modem is just being installed)
shown following the colon ( : ) on the first line and with all available selections listed on the
second line. Following this is a description of the configuration option. Factory default settings are
listed in Appendix F.
Miscellaneous Configuration Options — Mux DISABLED
StrapsWhenDisc: No_Change
Nxt No_Change Reload
Straps When Disconnected. Determines whether or not configuration options in the Active (Saved) configuration area
are reloaded to Active (Operating) when a disconnect occurs. This is useful in modem pooling applications.
No Change – Configuration options do not change if a disconnect occurs.
Reload – The Active (Operating) configuration area, which controls modem operation, is reloaded from the Active
(Saved) configuration area when a disconnect occurs. This is useful in modem pooling applications where it is desirable
to start the modem from a known condition after every call. This allows multiple users to issue AT commands to change
the modem's operation for their particular call.
NOTE: If Reload is selected, the following AT commands are disabled although the OK result code appears when the
following commands are issued: AT&F0, AT&F1, AT&F2, AT&F3, AT&F4, AT&F5, AT&F6, AT&F7, AT&F8,
AT&W0, AT&W1, AT&W2, and AT&Z n = x .
The AT command for the Straps When Disconnected configuration option is S-Register S88= n , where n is 0 or 231 for
No_Change, and 1 or 232 for Reload.
Speaker Control: OnUntilCarr
Nxt OnUntilCarr Off On
Speaker Control. Determines if the speaker is OFF, ON until carrier signal is received by the modem, or ON all the time.
NOTE: Speaker Control can also be temporarily set using the Control branch; however, a reset or power cycle will
restore the modem to the Speaker Control and Speaker Volume configuration option settings.
The AT command for Off is M0
The AT command for On Until CD is M1.
The AT command for On is M2.
Speaker Volume: Medium
Nxt Medium Low High
Speaker Volume. Controls the level of speaker volume.
NOTE: Speaker Volume can also be temporarily set using the Control branch; however, a reset or power cycle will
restore the modem to the Speaker Control and Speaker Volume configuration option settings.
The AT command for Low is L0 or L1.
The AT command for Medium is L2.
The AT command for High is L3.
3920-A2-GN31-10
A
Table 4-14
(1 of 3)
April 1995
DCP Configuration
A
4-65